3S BMS 25A 12.6V 4S 16.8V 5S 21V 18650 Li-ion Lithium Battery Protection Board Circuit Charging Module PCM Polymer Lipo Cell PCB

The description states that there is temperature protection, but the wiring diagram does not show wiring for a thermister. How is the temperature protection wired?

can you help

works for 18650 batteries ?

Can you include the temperature sensor? If not, do you know another seller that can provide it?

Will this work for Li-Po battery ? 3S li-po means 11.1 V.The input could be 12.0~13.0V for charging in this case or it will damage the lipo pack ?

Can I connect just 2s?

Can this be setup as a 4S4P with 18650? or this can only do single parallel (1P)?

I need 3 S bms with a yellow wire to T terminal

does it balance 3 cell lipo battery's?????

for a 4 cell charging (that is 16.8 volts) what voltage should be the input? And if the input is lower in mA than the batteries, does it matter?

for how many batteries charging at the same time is this circuit for

Should an NTC 10KOhm be used as a temperature sensor on the back? What resistance value should the NTC have?

do you have the 3s connection diagram?

what is the charging input voltage and current???? (what should the DC transformer voltage and ampreg be)????

I want to connect 3S. You said, connect it like the 4S with the B2 removed.When i do that, i get only 6.2V from a 3S pack. What's wrong? Is the BMS faulty?

I bought a BMS for 3S. How are 3S connected? In the description there are only 4S and 5 S.

Она балансирует аккумуляторы в сборке?

I’ve wired this board exactly as pictured with 5x18650 cells. Everything is soldered properly. I’ve left the power supply connected for a couple hours and when I disconnect the power supply, the battery board does not send power to my Bluetooth speaker. Please help!!